Accessories
Extend your Sensar Marine equipment
Accessory Extension Cable
This extension cable has 5 pins and is available in two lengths: 3 meters and 6 meters. Multiple cables can be easily daisy-chained together.
The accessory extension cable can be used to extend the distance between the Boat Monitor and either the Bilge Sentry or Expansion Hub.
Note: cable is 'keyed' differently than an NMEA 2000 drop cable and the two are not interchangeable
Shore Power Sensor
The Sensar Marine Expansion Hub requires an AC to DC transformer to monitor your shore power connection. For your convenience, you can purchase this item from Sensar Marine.
We offer the transformer in two versions:
Hardwired -> perfect for skilled installers
Plug-in -> easier for DIY, includes interchangeable AC blades to fit in standard outlets worldwide
Fire Alarm Interface Cable
Required cable for connecting compatible marine fire detection systems to the Sensar Marine Expansion Hub.
Enables remote monitoring of fire alarm status, system faults, and active alarm conditions.
Includes a pre-wired interface module with a 4m marine-grade tinned cable to the Expansion Hub and four raw-terminated leads (0.5m) for the connection to the fire alarm system.
Theft Alarm Resistor Cable
The Sensar Marine Expansion Hub needs a specially configured wire to protect your outboard engine from theft. For your convenience, you can purchase this item from Sensar Marine.
Cable has a factory-installed end-of-line resistor specially designed for use with the Sensar Marine Expansion Hub's theft alarm input.
Enables tamper detection by allowing the system to distinguish between a normal closed loop, a cut wire, and an attempted short-circuit bypass.
Cable total length is 8m, all marine-grade fully tinned wire